optimize drives The parameter is incorrect. (0x80070057)

Anonymous
2013-07-21T15:58:57+00:00

cant optimize one of my storage drives. its starts of analyzing drive then just never actually does a defrag.

in event viewer im getting this error for the drive in question: "was not optimised because an error was encountered: The parameter is incorrect. (0x80070057)".

the drive passes error checking with no problems.

any help would be greatly appreciated

Windows for home | Previous Windows versions | Performance and system failures

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments
Answer accepted by question author
Anonymous
2014-04-01T17:24:55+00:00

This issue is officially corrected by Microsoft. Go here to get the Hotfix:HotFix for Event Log Error 257

Was this answer helpful?

1 person found this answer helpful.
0 comments
Answer accepted by question author
Anonymous
2014-02-10T19:48:47+00:00

I finally found a solution that worked for me here:

http://social.technet.microsoft.com/Forums/en-US/6d782ade-f4de-43bf-8cea-647828b35757/strange-defrag-error-0x80070057?forum=winserverfiles

Open an Administrator command prompt and make use of fsutil:

fsutil usn deletejournal /D <volume pathname>

fsutil usn createjournal m=<max-value> a=<alloc-delta> <volume pathname>

Eg :

fsutil usn deletejournal /D C:

fsutil usn createjournal m=1000 a=100 C:

After using these commands I was able to defragment C: without an error showing up in the event viewer. I'm not sure if this is a permanent or temporary fix, and someone mentioned in that thread that it didn't work with a server so YMMV.

Was this answer helpful?

1 person found this answer helpful.
0 comments

47 additional answers

Sort by: Most helpful
Most helpful Newest Oldest
  1. Anonymous
    2013-10-19T10:34:58+00:00

    still getting this issue on 8.1 final....fresh install

    Was this answer helpful?

    0 comments
  2. Anonymous
    2013-08-16T13:21:05+00:00

    You could try to reset the repository folder.

    Start the command prompt as admin and type the following commands.

    Confirm every line by pressing "Enter".

    net stop winmgmtcd /d %windir%\system32\wbemren repository repository.oldnet start winmgmtexitAfter that restart the pc and test if the error occurs again.

    Was this answer helpful?

    0 comments
  3. Anonymous
    2013-08-16T11:57:16+00:00

    Hi,

    Did you perform a repair or clean install?

    If you have performed a clean install by formatting the drive and the issue still persists then the problem could be with the drive itself.

    Was this answer helpful?

    0 comments