irql not less or equal

Anonymous
2024-08-20T07:57:30+00:00

Hello, I had the BSOD Code that says "IRQL_NOT_LESS_OR_EQUAL" And i cant find a solution, i tried reinstall windows

i tried to buy new ram. i literally tried everything, can i get some help?

Windows for home | Windows 10 | Performance and system failures

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments

49 answers

Sort by: Oldest
Most helpful Newest Oldest
  1. Anonymous
    2024-08-20T11:56:47+00:00

    Hey again, sorry for late response, where can i find the results?

    Was this answer helpful?

    0 comments
  2. Anonymous
    2024-08-20T12:04:15+00:00

    Nevermind i find that, dont worry,

    Was this answer helpful?

    0 comments
  3. DaveM121 935.1K Reputation points Independent Advisor
    2024-08-20T13:56:20+00:00

    If no RAM errors were found, please follow the steps in number 2 above to enable Driver Verifier

    Was this answer helpful?

    0 comments
  4. Anonymous
    2024-08-20T14:02:26+00:00

    Can you give me instructions again please?

    Was this answer helpful?

    0 comments
  5. DaveM121 935.1K Reputation points Independent Advisor
    2024-08-20T14:30:47+00:00

    To try to force Windows show any faulting drivers, the best option would be to turn on Driver Verifier, let your PC crash 3 times, then you must turn off Driver Verifier, and finally, upload any newly created minidump files

    Before you run Driver Verifier, please create a new System Restore Point

    https://answers.microsoft.com/en-us/windows/for...

    Note, if you have any difficulty getting into Windows with Driver Verifier enabled:

    Start your PC, just as Windows attempts to load (spinning dots), press and hold Power Button for 5 - 10 seconds to perform a Hard Shut Down

    Do this twice

    On the third start Windows will boot into the Recovery Environment and from there you can access System Repair, Safe Mode, Command Prompt... etc.

    Go to Troubleshoot - Advanced Option - Startup Settings and click Restart

    Upon restart, press 4 to enter Safe Mode

    Open Command Prompt as Administrator and run these two commands, then restart your PC.

    verifier /reset

    verifier /bootmode resetonbootfail

    Was this answer helpful?

    0 comments