After installation of KB4056892 boot failure, after roll-back error 0x800f0845

Today I got another KB4056892 update and it is pending a instal.  The known issues states they are not sending them for systems with AMD CPU's.

How to exclude the Update:

• If possible in your Windows 10 version, set your connection as "metererd", this will stop automatic download of updates
• use the Hide/Show troubleshooter to hide the Update
• if the Update is not "waiting for restart" in Windows Update, you can restart the pc now
• if instead the Update is in the "waiting for restart" state, it is already listed in the uninstallable updates so you can uninstall it How to Uninstall a Windows Update in Windows 10 and then restart your pc
• wait some minutes and then check Windows Update to verify that the Update is now ignored
• reset your connection to not metered

Tested on Windows 10 Fall Creators Update Home and Pro.

Thanks 

Did it and will wait ti see if it works.

It's only a surmise but maybe your machine had already been flagged for the update prior to the withdrawal of KB4056892 for affected AMD systems. The exact timing of the withdrawal is not stated.

In my experience its not really a big problem, after three failed boots the update was auto-reverted and my machine was again usable, as before.

Then, I took two actions to suspend it. Firstly I logged in as admin, and changed the Windows Update 'Advanced Options', to pause updates for 35 days. This is only available on 'Pro' or better. I also used 'wushowhide.diagcab', to remove KB4056892 from the queued update list.

I've not tested it, but folk on 'Home', may find the second option is sufficient on its own.

It did not try to install the update this morning when I turned on my computer. It think it happens yesterday because their were other updates pending.

This the one awaiting restart.

Installed updates is a mess. Note it shows the bad update installed and restart a restart to finish installing it. That is the 6th time it tried installing. I think the one that says installed should be uninstalled since I had a uninstall pending restart.

Another one that installed yesterday.

I don't think I can uninstall the available update but can uninstall the one shown installed and the one not finished.

Not sure how to use "'wushowhide.diagcab". Tryed command promt but it failed to run. Not that famililar with doing such commands. 

Thankis for the help

My last successful update was KB4058702. 

KB4056892 also failed to update in my laptop after multiple tries of updates, installs and restarts. I am using a multiple boot system that I have to pick OS on startup. I use a Dell Precision M2800, 64-bit, i7-4810MQ CPU, 16GB RAM, Win 10 Pro.

Because KB4056892 failed to update on multiple retries, my laptop becomes very slow to a point it's unusable (although it managed to boot). I am disabling windows update services until there is a resolution and using my previous stable restore point.