My Windows 8.1 is stuck in an automatic repair loop, how can I fix this?

Anonymous
2014-01-02T16:49:35+00:00

my laptop will not boot at all, when I turn it on the screen shows 'preparing automatic repair' then 'diagnosing your PC'. After this, the screen shows 'your PC did not start correctly' and it doesn't work when I restart it so I selected advanced options. After this, if I click continue the repair screen appears again and I am redirected back to the same page. I can't access my desktop at all and an administrator hasn't been set on my laptop, so after clicking troubleshoot I can't refresh or reset my PC.After this I clicked on advanced settings and I cannot choose system restore, command prompt, system image recovery or startup repair because they either don't work or need an administrator and I haven't set one as I mentioned before. My last resort was startup settings which requires restarting the PC. 9 options are to choose from and I tried almost all and it won't boot up in safe mode. Help!

Windows for home | Previous Windows versions | Windows update

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments
Answer accepted by question author
Anonymous
2014-04-02T19:25:00+00:00

I've inserted the System Recovery disc 1 that came with the computer. No change.

Usually that means that that device is not higher than the hard drive in the boot device order.  You would probably need to get into your BIOS screen to change that.  See your User Guide or contact HP for more information.  Post your product id (e.g. what details you need to use HP's site to find your particular documentation and downloads but not your serial number) if you need someone to help interpret your user documentation.  In W7 HP had a nice tool that gave me those details.  I never found anything analogous from W8, except in bits and pieces.

HTH

Robert Aldwinckle

Was this answer helpful?

200+ people found this answer helpful.
0 comments

156 additional answers

Sort by: Oldest
Most helpful Newest Oldest
  1. Anonymous
    2014-09-10T13:38:19+00:00

     run on the PC that I want to upgrade, which is impossible because the PC I want to upgrade is stuck in the Automatic Repair Loop.

    Not if you change the boot order in the BIOS.

    Was this answer helpful?

    0 comments
  2. Anonymous
    2014-09-10T13:43:39+00:00

    Hello Seth,

    Thank you for the response.

    As you mentioned earlier that you are able to access recovery options, I would suggest you to run check disk from command prompt to fix errors in the hard drive which may be causing the issue. Please follow these steps:

    a. Open command prompt in recovery options.

    b. Type the following command in command prompt and press Enter.

    chkdsk /f /r

    Check disk may take some time to complete.

    c. Close command prompt and restart the computer, when check disk completes.

    Note: While performing chkdsk on the hard drive if any bad sectors are found on the hard drive when chkdsk tries to repair that sector if any data available on that might be lost.

    I hope it helps.

    Thank you

    Was this answer helpful?

    0 comments
  3. Anonymous
    2014-09-10T13:47:58+00:00

    How will changing the boot order allow me to access a webpage using a PC that is stuck in an Automatic Repair Loop?

    Was this answer helpful?

    0 comments
  4. Anonymous
    2014-09-10T13:59:13+00:00

    chkdsk/f/r returns:

    The type of the file system is NTFS. 

    Cannot lock current drive.

    Windows cannot run disk checking on this volume because it is write protected.

    Was this answer helpful?

    0 comments