Error "Start PXE over IPv4" on startup on Windows 8

Anonymous
2013-05-20T01:18:48+00:00

Original Title:   What is this delay in starting Windows 8????

When I turn on my laptop, instead of immediately going to the start page of windows 8, my screen is black with the Dell logo, and a message to the left that says 'Start PXE over IPv4'. after a good while it then says 'FXE-E18 Server Response Timeout'. then after another while, it says 'Start PXE over IPv6'. then after another minute or more wait it says, 'FXE-E16 no offer received', and the little spinning balls start spinning and the start page finally shows up? What is this delay in 'connection (it's probably a good 3 minutes, maybe more)? What does this mean?

Windows for home | Previous Windows versions | Performance and system failures

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments No comments
Answer accepted by question author
Anonymous
2013-05-20T21:23:12+00:00

Thank you for your kind words, although I think a few on here might disagree with you.  Sometimes a simple 2 or 3 sentence answer is more useful than links, screen grabs and pages of information.

Having made the hard disk the 1st boot device if you ever need to boot from DVD just press the F12 key and you get a one time boot device selector, far easier than changing things in the BIOS.

Please mark your choice as an answer to move this thread to Answered

Was this answer helpful?

500+ people found this answer helpful.
0 comments No comments

55 additional answers

Sort by: Oldest
  1. Anonymous
    2016-05-23T21:23:19+00:00

    Thank you. I just needed to go back to legacy mode and it is OK again.

    Was this answer helpful?

    0 comments No comments
  2. Anonymous
    2016-10-13T22:07:49+00:00

    Just run your laptop or system by changing bios to legacy mode then your system or laptop will start faster.

    Was this answer helpful?

    0 comments No comments
  3. Anonymous
    2016-10-14T07:13:59+00:00

    If putting the BIOS  in legacy mode speeds up boot (not always the case) it will ONLY affect the BIOS sequence time. Legacy mode is not optimal for modern operating systems and may slow Windows down. Gaining a few seconds during boot would have to be traded of against reduced performance the rest of the time.

    What would be the point of introducing a new high performance (UEFI) BIOS if it was actually slower than legacy systems in normal operation. Starting a computer represents a very small part of its use. If you really need speed fit an SSD, faster boot AND faster use.

    Was this answer helpful?

    0 comments No comments
  4. Anonymous
    2016-12-13T17:50:21+00:00

    So after I hit F2 the screen just goes black and after a while it displays the IPv4 error again...Any solution?

    Was this answer helpful?

    0 comments No comments