Windows 8 is stuck in an automatic repair loop

Anonymous
2012-10-26T21:04:03+00:00

My windows 8 get in a automatic repair loop and it couldn't repair it. And than it says log file d:\windows\system32\logfiles\srt\srttrail.txt

What to do?

Windows for home | Previous Windows versions | Windows update

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments
Answer accepted by question author
Anonymous
2012-10-29T14:14:32+00:00

do a selective boot up with bios

get cmd to open and check

bootrec /fixMBR

bootrec /Fixboot

bootrec /rebuildBCD

and also

chkdsk /r c:

chkdsk /r d:

chkdsk /r e:

chkdsk /r f:

then let repair go thowe again and should be stoped

Was this answer helpful?

200+ people found this answer helpful.
0 comments
Answer accepted by question author
Anonymous
2014-12-31T16:33:06+00:00

Hello Coonut,

Thank you for your reply,

I would suggest you to login to any other computer and create a Windows 8 installation disk. Using that disk you can perform the troubleshooting methods given below.

Refer the link to create the installation disk:

How to create installation media for a PC refresh or reset:

http://windows.microsoft.com/en-us/windows-8/create-reset-refresh-media

Hope the information helps.

Please reply with the results, in order to help you fix the issue.

Wish u a Happy New Year!

Thank you

Was this answer helpful?

70+ people found this answer helpful.
0 comments

280 additional answers

Sort by: Newest
Most helpful Newest Oldest
  1. Anonymous
    2015-08-28T05:49:28+00:00

    I got stuck in the automatic repair loop as well a while back, and I tried several of the options listed below, but none of them solved the problem permanently. The issue was in my case apparently caused by an aging hard drive. I've put the HDD of my old pc in my new one to have some extra storage. My solution when stuck in automatic repair:

    • switch OFF the pc
    • unplug the cable to the hard drive (not the one with windows installed on)
    • switch ON the pc
    • switch OFF the pc
    • reconnect the hard drive
    • switch ON the pc
    • done!

    I hope this may help some of you as well. Good luck!

    Was this answer helpful?

    0 comments
  2. Anonymous
    2015-08-28T04:35:21+00:00

    Hello sir.. How can you do a selective boot up with bios?

    Was this answer helpful?

    0 comments
  3. Anonymous
    2015-08-20T01:00:23+00:00

    do a selective boot up with bios

    get cmd to open and check

    bootrec /fixMBR

    bootrec /Fixboot

    bootrec /rebuildBCD

    and also

    chkdsk /r c:

    chkdsk /r d:

    chkdsk /r e:

    chkdsk /r f:

    then let repair go thowe again and should be stoped

    Not working for me...

    Was this answer helpful?

    0 comments