Event says when my system froze that "The DgiVecp service failed to start due to the following error: The system cannot find the file specified."

Anonymous

I found the exact problem that causes this freezes. My computer freezed today at 20:17. I went to the event viewer and found that at that time there is an event says that "The DgiVecp service failed to start due to the following error: The system cannot find the file specified."

Is there anyone who knows about it?

Thank you.

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments

Answer accepted by question author

Anonymous

Hi, Tekinalp67,

Try Gloria's Suggestion from this thread-

http://answers.microsoft.com/en-us/windows/forum/windows_vista-hardware/error-6008/5a6138d1-e997-4d74-98a4-bb974c4114c1

-Or-

Start > Type Regedit

Press Enter

Navigate to the following key:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services

Look for an entry listed as DgiVecp

If you find this, then change the Start data value to 4.

Reboot the system and see if the message is gone.

http://tzatziki-solvedproblems.blogspot.com/2010/02/dgivecp.html

0 comments

Answer accepted by question author

Anonymous

Event ID 6008 - is it still showing up in Event Viewer? Possibilities were heat, video drivers, faulty devices, failing HD's etc

Event ID: 41 Source: Kernel-Power

Source: Kernel-Power
Type: Critical
Description: <br><br>The last sleep transition was unsuccessful. This error could be caused if the system stopped responding failed or lost power during the sleep transition.<br><br><br> <br><br><br>Check for loose connections - did you change power settings to never?<br><br><br>CPU could be overheating<br><br><br>Driver software could be at fault<br><br><br>http://www.eventid.net/display.asp?eventid=41&eventno=9230&source=Kernel-Power&phase=1<br><br><br> <br><br><br> <br><br><br>Boot your system in a clean boot state. When it is up in a clean boot state, activate the sleep mode process. If it has not problems coming out of sleep mode when in the clean boot state, add a few more services back and try the process again. Continue until<br> the issue occurs, then the issue is probably one of the driver's/services that were last enabled that is conflicting with the process sleep undertakes to place the system in sleep mode.<br> <br><br> <br><br>Here are the steps for clean boot; - I recommend updating all drivers and firmware as a step in resolving this as well. <br><br> <br><br>CLEAN BOOT: you can use the steps in the article to narrow down the cause of the problem,http://support.microsoft.com/kb/929135. <br><br>(Step 1 is listed below.) <br><br>Step 1: Perform a clean boot Note If the computer is connected to a network, network policy settings may prevent you from following these steps. We strongly recommend that you do not use the System Configuration utility to modify the advanced<br> boot options on the computer unless a Microsoft support engineer directs you to do this. Doing this may make the computer unusable.<br><br><ol><br><li>Log on to the computer by using an account that has administrator rights. </li><li>Click <strong>Start<br><div><img src="http://support.microsoft.com/library/images/support/kbgraphics/Public/EN-US/VistaStartButton.jpg"></div><br>, type <span>msconfig.exe</span> in the <strong>Start Search box, and then press ENTER to start the System Configuration Utility.<br><br><br><br><div><img src="http://support.microsoft.com/library/images/support/kbgraphics/Public/EN-US/SecurityShield.jpg"></div><br>If you are prompted for an administrator password or for confirmation, type your password, or click<strong>Continue.<br></strong></strong></strong>Regards,<br><br><br><br></li><li>On the <strong>General tab, click <strong>Selective Startup, and then click to clear the<strong>Load startup items check box. (The<br><strong>Use Original Boot.ini check box is unavailable.)</strong></strong></strong></strong></li><li>On the <strong>Services tab, click to select the <strong>Hide all Microsoft services check box, and then click<strong>Disable all.<br><br><br><br><strong>Note</strong> Following this step lets Microsoft services continue to run. These services include Networking, Plug and Play, Event Logging, Error Reporting, and other services. If you disable these services, you may permanently delete all restore points.<br> Do not do this if you want to use the System Restore utility together with existing restore points.</strong></strong></strong></li><li>Click <strong>OK, and then click <strong>Restart.</strong></strong> </li></ol><br><br>http://answers.microsoft.com/en-us/windows/forum/windows_vista-hardware/cannot-awake-from-sleep/fa423ca9-2412-49b5-9f97-37c43a1419c5

Source: Kernel-Power

Type: Critical

Description: The last sleep transition was unsuccessful. This error could be caused if the system stopped responding failed or lost power during the sleep transition. Check for loose connections - did you change power settings to never? CPU could be overheating Driver software could be at fault http://www.eventid.net/display.asp?eventid=41&eventno=9230&source=Kernel-Power&phase=1 Boot your system in a clean boot state. When it is up in a clean boot state, activate the sleep mode process. If it has not problems coming out of sleep mode when in the clean boot state, add a few more services back and try the process again. Continue until the issue occurs, then the issue is probably one of the driver's/services that were last enabled that is conflicting with the process sleep undertakes to place the system in sleep mode. Here are the steps for clean boot; - I recommend updating all drivers and firmware as a step in resolving this as well. CLEAN BOOT: you can use the steps in the article to narrow down the cause of the problem,http://support.microsoft.com/kb/929135. (Step 1 is listed below.) Step 1: Perform a clean boot Note If the computer is connected to a network, network policy settings may prevent you from following these steps. We strongly recommend that you do not use the System Configuration utility to modify the advanced boot options on the computer unless a Microsoft support engineer directs you to do this. Doing this may make the computer unusable. <ol> <li>Log on to the computer by using an account that has administrator rights. </li><li>Click Start <div><img src="http://support.microsoft.com/library/images/support/kbgraphics/Public/EN-US/VistaStartButton.jpg"></div> , type msconfig.exe in the Start Search box, and then press ENTER to start the System Configuration Utility. <div><img src="http://support.microsoft.com/library/images/support/kbgraphics/Public/EN-US/SecurityShield.jpg"></div> If you are prompted for an administrator password or for confirmation, type your password, or clickContinue. Regards, </li><li>On the General tab, click Selective Startup, and then click to clear theLoad startup items check box. (The Use Original Boot.ini check box is unavailable.)</li><li>On the Services tab, click to select the Hide all Microsoft services check box, and then clickDisable all. Note Following this step lets Microsoft services continue to run. These services include Networking, Plug and Play, Event Logging, Error Reporting, and other services. If you disable these services, you may permanently delete all restore points. Do not do this if you want to use the System Restore utility together with existing restore points.</li><li>Click OK, and then click Restart. </li></ol> http://answers.microsoft.com/en-us/windows/forum/windows_vista-hardware/cannot-awake-from-sleep/fa423ca9-2412-49b5-9f97-37c43a1419c5

0 comments

80 additional answers

Anonymous

2012-01-16T18:46:07+00:00

I got a new crash today after 8 days.

Please someone tell me what is that. Is it a hardware problem or not? If it is a hardware problem should not I get this error frequent?

HELPPPPPPPPPPP
Was this answer helpful?

0 comments No comments
Anonymous

2012-01-08T16:46:16+00:00

I uninstalled Norton a used the computer from that time to time. During this time, I open the computer and check whether there was a problem or not. I found 2 paper which were approximately 4cm long and 1 cm wide. I removed them. Until today I did not receive the problem. I played games, programming, watching video and surfing during this period which is 10 days.

In this case the screen goes to orange. sometimes it goes to black blue. I checked in Computer properties to automatically restart. But the computer does not restart. What was the problem? I check the CPU and RAM with Intel Burn Test and it pass with 100 percent in 64 bit windows. I think it is not because of PSU because I am playing lots of games for hours and nothing happened. Only things that come to my mind are motherboard and graphics card. I ran a software of ASUS and it says there is nothing bad on these cards as well. What is the problem?
Was this answer helpful?

0 comments No comments
Anonymous

2011-12-31T01:58:09+00:00

Opps the hotfix is not suitable for me then.

Now only 2.99 gb is usable for 32 bit. Can norton internet security cause this problem?

Yes, Norton can cause many issues.

Try uninstalling it long enough for testing purposes. Download and install MSE (freeware). Go about your computing business and see if there is a freeze.

http://windows.microsoft.com/en-US/windows/products/security-essentials

Security compatibility list shows Norton products as compatible. If your system is 32-bit, ensure you use 32-bit applications such as Norton with it.

http://www.microsoft.com/windows/compatibility/windows-7/en-us/default.aspx
Was this answer helpful?

0 comments No comments