How to install Teredo Tunneling Pseudo-Interface

Hi DocBrown,

Follow the steps mentioned below:

First, let’s temporarily disable antivirus softwareand Firewallon the computer as a test.

Note: Make sure you turn-on the antivirus software and Windows Firewall later.

Now, let’s verify the status of relevant services required.

1. Click Start , type services.msc in Start search box and hit Enter.
2. Right-click the Peer Networking Grouping service and select Properties .
3. Check if the service is started; if not, right-click and select Start .
4. You may also set the Startup type to Automatic under Properties .
5. Click OK .

Repeat the above steps for the service PNRP Machine Name Publication Service , **** too.

Next step would be to modify IPv6 registry key to enable IPV6:

ImportantThis section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:

How to back up and restore the registry in Windows

http://support.microsoft.com/kb/322756/

1. Click Start , type regedit in Start Search Bar and hit Enter.

**Note:**If you are prompted for an administrator password or confirmation, type your password or click Continue.

2. Locate and then click the following registry subkey:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\services\TCPIP6\Parameters

3. Check whether DisabledComponents registry key exists. If yes, let's proceed to the next step.
4. Double click the DisabledComponents registry key and modify the value to 0 .

If the DisabledComponents entry is unavailable, you must create it. To do this, follow these steps:

1. In the Edit menu, point to New , and then click DWORD (32-bit) Value .
2. Type DisabledComponents , and then press ENTER.
3. Double-click DisabledComponents .

Type 0 to enable all IPv6 components.

5. Exit Registry Editor, and then restart the computer.

Refer:

How to disable certain Internet Protocol version 6 (IPv6) components in Windows Vista, Windows 7 and Windows Server 2008

http://support.microsoft.com/kb/929852

Hope this helps.

Gokul - Microsoft Support

[If this post was helpful, please click the "Vote as Helpful" (green triangle) button. If it helps in resolving your issue, click "Propose As Answer" or "Mark as Answer" button. By proposing/marking a post as Answered, or Helpful you help others find the answer faster.]

Have you enabled the option - show hidden devices ?

Device Manager > View > CHECK show hidden devices.

Expand Network adapters

Is Microsoft Teredo Tunneling Adapter listed?

Cheers!

'Tis all a chequer board of nights and days,

Where destiny with men for pieces plays;

Hither and thither, and mates, and slays.

In a world without walls and fences, who needs Windows and Gates?! Life sucks! Get used to it!